PR Paperless Recorder
Page 6 of 38
 
PC based Alarm Relay Output

An optional relay card can be used to provide ONE local alarm relay output (any system alarm) at the computer that can be used for audible and/or visual indication of an alarm to alert operators in the vicinity of the PC as well as another relay output to operate an auto dialer.

EnVision USB Relay Card

The Main Alarm Contact selections allow the user to choose which relay (K0 – K7) will be used for the alarm contact (only one relay can be selected).

The Auto Dialer Alarm Contact selections allow the user to choose which relay (K0 – K7) will be used for the auto dialer control contact. Note that the Auto Dialer Alarm contact will reset itself after the configured time period to be ready to dial out again if other alarms occur.

Relay Card Installation

The Ontrak ADU208 relay card is a USB interface device and can be plugged in to any available USB port on the computer.  Power for the operation of the card is provided through the USB connection.  There are 8 type “A” relay contact outputs in the ADU208 rated at 5A@120VAC or 5A@30VDC.


Page Navigation - Jump to the specific page in the EnVision Tour
 

1. EnVision Navigation
2. Device Thumbnails Overview
3. Digital Values
4. System Alarms
5. EnVision Device Alarms
6. PC based Alarm Relay Output
7. General and Service Device Notes
8. Real-Time Trends
9. Single Loop Tuning
10. Data Logging Overview
11. System Data Logging
12. Device Data Logging / Historical Data File
13. Logging Overview Monitor
14. Historical Data File Viewing
15. Searching Historical Data Files
16. Historical Data File Trend Plot
17. CFR21 Part 11 and NADCAP AMS2750E: Historical Data files (Data Log) and Digital Signatures
18. Orion-Mi / nCompass CM Detail View

   

19. Orion-Mi / nCompass CM Detail View Tab
20. Orion-Mi / nCompass CM Detail View: Auto Tune and Auto/Manual Tabs

21. Orion-Mi / nCompass CM Data Logging Tab
22 Orion-Mi / nCompass CM Schedules Tab (Ramp/Soak Profiles)
23. Orion-Mi / nCompass CM Profile/Schedules: Run, Stop & Hold Profile Schedules

24. Orion-Mi / nCompass CM Schedule Editor Overview
25. Orion-Mi / nCompass CM Schedule Editor: Guaranteed Soak, Loops Active and Auto Start
26. Orion-Mi / nCompass CM Schedule Editor: Stage "Wait For"

27. Orion-Mi / nCompass CM Schedule Editor: Schedule Notes
28. Orion-Mi / nCompass CM - Setup Tab
29. Orion-Mi / nCompass CM Detail View - Setup/IO Monitor
30. Orion-Mi / nCompass CM Detail View - Setup/Schedule Options

 
 
 
Future Design Controls   888.751.5444   csr@futuredesigncontrols.com