PR Paperless Recorder
Page 36 of 38
 

Configuring EnVision

The EnVision Configurator program provides easy setup parameters for each Device on the link (Loop Control, Analog Input Card or Orion-M iSeries).

The configurator is used to select the type of Device that is installed at a given address and in the case of the Orion-Mi / nCompass CM controllers, define how many control loops, monitor points, inputs and outputs the Orion-Mi / nCompass CM have. The configurator also provides a manner to assign names to each device, events, process alarms, etc.

All of the configuration data entered for each Device is used by EnVision to define how and what information is to be displayed. This allows EnVision to be tailored to each individual Device, and only display information for available options on the Device.  It also allows you to omit certain options if you do not want them shown or accessible throughout EnVision.

The Tab based configuration window makes it easy and intuitive to develop a system configuration.

The “Main” tab is used to select the type of controller that is present at each address on the communications link.  The “Device Type” drop down menu next to each controller address to select the type of controller that is present at that communications address.

EnVision Configuration Device Type

The remaining tabs are configured in the same fashion

EnVision Configuration Device Type
EnVision Configuration Device Type
EnVision Configuration Device Type

Page Navigation - Jump to the specific page in the EnVision Tour
 

1. EnVision Navigation
2. Device Thumbnails Overview
3. Digital Values
4. System Alarms
5. EnVision Device Alarms
6. PC based Alarm Relay Output
7. General and Service Device Notes
8. Real-Time Trends
9. Single Loop Tuning
10. Data Logging Overview
11. System Data Logging
12. Device Data Logging / Historical Data File
13. Logging Overview Monitor
14. Historical Data File Viewing
15. Searching Historical Data Files
16. Historical Data File Trend Plot
17. CFR21 Part 11 and NADCAP AMS2750E: Historical Data files (Data Log) and Digital Signatures
18. Orion-Mi / nCompass CM Detail View

   

19. Orion-Mi / nCompass CM Detail View Tab
20. Orion-Mi / nCompass CM Detail View: Auto Tune and Auto/Manual Tabs

21. Orion-Mi / nCompass CM Data Logging Tab
22 Orion-Mi / nCompass CM Schedules Tab (Ramp/Soak Profiles)
23. Orion-Mi / nCompass CM Profile/Schedules: Run, Stop & Hold Profile Schedules

24. Orion-Mi / nCompass CM Schedule Editor Overview
25. Orion-Mi / nCompass CM Schedule Editor: Guaranteed Soak, Loops Active and Auto Start
26. Orion-Mi / nCompass CM Schedule Editor: Stage "Wait For"

27. Orion-Mi / nCompass CM Schedule Editor: Schedule Notes
28. Orion-Mi / nCompass CM - Setup Tab
29. Orion-Mi / nCompass CM Detail View - Setup/IO Monitor
30. Orion-Mi / nCompass CM Detail View - Setup/Schedule Options

 
 
 
Future Design Controls   888.751.5444   csr@futuredesigncontrols.com