PR Paperless Recorder
Page 32 of 38
 

Security

EnVision's security features, along with digital signatures for historical data files and software life cycle and validation documentation, provide CFR21 Part 11 compliance.

The Security features are not just applicable to the pharmaceutical industry.  Any industry that requires secure data files, audit trails and authenticated logins to initiate process changes can take advantage of these features.  The security can also be turned off for companies that do not require security in their systems.

Configure Security
Security Setup is a multi-tab interface divided into three sections.

EnVision Security Configure Add User

The Add User tab provides the ability to add up to 30 users to the system divided into 4 user groups; System, Operator, Supervisor and Administrator levels. 

If password aging is enabled and the password has expired, the user will be prompted to enter a new password before they can log into the system again.

Users
The “Users” tab provides the ability to view information on each user entered into the system.  Password information is not available.

EnVision Security Configure Users

Rights and Options
The "Rights and Options" tab provides the ability to set security access rights (70+ rights) for each user level as well as enable and disable security options.

EnVision Security Configure Rights and Options

Page Navigation - Jump to the specific page in the EnVision Tour
 

1. EnVision Navigation
2. Device Thumbnails Overview
3. Digital Values
4. System Alarms
5. EnVision Device Alarms
6. PC based Alarm Relay Output
7. General and Service Device Notes
8. Real-Time Trends
9. Single Loop Tuning
10. Data Logging Overview
11. System Data Logging
12. Device Data Logging / Historical Data File
13. Logging Overview Monitor
14. Historical Data File Viewing
15. Searching Historical Data Files
16. Historical Data File Trend Plot
17. CFR21 Part 11 and NADCAP AMS2750E: Historical Data files (Data Log) and Digital Signatures
18. Orion-Mi / nCompass CM Detail View

   

19. Orion-Mi / nCompass CM Detail View Tab
20. Orion-Mi / nCompass CM Detail View: Auto Tune and Auto/Manual Tabs

21. Orion-Mi / nCompass CM Data Logging Tab
22 Orion-Mi / nCompass CM Schedules Tab (Ramp/Soak Profiles)
23. Orion-Mi / nCompass CM Profile/Schedules: Run, Stop & Hold Profile Schedules

24. Orion-Mi / nCompass CM Schedule Editor Overview
25. Orion-Mi / nCompass CM Schedule Editor: Guaranteed Soak, Loops Active and Auto Start
26. Orion-Mi / nCompass CM Schedule Editor: Stage "Wait For"

27. Orion-Mi / nCompass CM Schedule Editor: Schedule Notes
28. Orion-Mi / nCompass CM - Setup Tab
29. Orion-Mi / nCompass CM Detail View - Setup/IO Monitor
30. Orion-Mi / nCompass CM Detail View - Setup/Schedule Options

 
 
 
Future Design Controls   888.751.5444   csr@futuredesigncontrols.com