PR Paperless Recorder
Page 31 of 38
 

Profiling: Loop Controls

P-Series Profiler Loop Controls

The P-Series Profile Loop Controls may be accessed directly from EnVision

The P Series profiling loop controls offer the following features:

  • Profiles: up to 9 profiles
  • Steps/Stages: up to 64 steps per profile
  • Control Outputs: up to 4 outputs configurable as Control, Alarm, Event, Retransmission and Communication outputs
  • Event Input for multiple functions including Step Advance Wait For logic, profile start, hold, stop and more.

The "Profile Entry" tab allows the user to open, create, edit and save profiles from the PC interface.  It also provides the user with the ability to download profiles to the selected P-Series controller. 

The "Profile Notes" tab allows the user to notes for a specific profile.

The "Profile Run" tab allows the user to start, stop and hold the downloaded profile in the selected P-Series controller. 

    
P Series Loop Control Profile Entry

Profiles can be created or edited at any time during operation. All profiles are saved directly to the hard drive of the PC making them available for download to any P-Series control in the system, not just the one currently selected.

Each individual P-Series control available in the system can be selected from the drop down list at the top right of the screen.  This allows the user to select the control to download the profile to.

EnVision P Series loop control Profile Entry

The toolbar icons for profile editing are as follows (order from left to right):

    
P Series Loop Controls Profile Notes

Profile notes are accessed from the “Profile Notes” tab.

EnVision P Series loop control Profile Notes

Notes can be entered with up to 255 characters each and are saved with the Profile.  When a new note is created, it is automatically tagged by date and time of creation. 

    
P Series Loop Controls Profile Run

The Profile Run tab allows the user to view the profile operating status of the profile, as well as start, stop and hold the currently running profile. 

EnVision P Series loop control Profile Run Hold Stop

Page Navigation - Jump to the specific page in the EnVision Tour
 

1. EnVision Navigation
2. Device Thumbnails Overview
3. Digital Values
4. System Alarms
5. EnVision Device Alarms
6. PC based Alarm Relay Output
7. General and Service Device Notes
8. Real-Time Trends
9. Single Loop Tuning
10. Data Logging Overview
11. System Data Logging
12. Device Data Logging / Historical Data File
13. Logging Overview Monitor
14. Historical Data File Viewing
15. Searching Historical Data Files
16. Historical Data File Trend Plot
17. CFR21 Part 11 and NADCAP AMS2750E: Historical Data files (Data Log) and Digital Signatures
18. Orion-Mi / nCompass CM Detail View

   

19. Orion-Mi / nCompass CM Detail View Tab
20. Orion-Mi / nCompass CM Detail View: Auto Tune and Auto/Manual Tabs

21. Orion-Mi / nCompass CM Data Logging Tab
22 Orion-Mi / nCompass CM Schedules Tab (Ramp/Soak Profiles)
23. Orion-Mi / nCompass CM Profile/Schedules: Run, Stop & Hold Profile Schedules

24. Orion-Mi / nCompass CM Schedule Editor Overview
25. Orion-Mi / nCompass CM Schedule Editor: Guaranteed Soak, Loops Active and Auto Start
26. Orion-Mi / nCompass CM Schedule Editor: Stage "Wait For"

27. Orion-Mi / nCompass CM Schedule Editor: Schedule Notes
28. Orion-Mi / nCompass CM - Setup Tab
29. Orion-Mi / nCompass CM Detail View - Setup/IO Monitor
30. Orion-Mi / nCompass CM Detail View - Setup/Schedule Options

 
 
 
Future Design Controls   888.751.5444   csr@futuredesigncontrols.com