PR Paperless Recorder
Page 28 of 38
 

Orion Series – Setup Tab

From the Orion Detail View the “Setup” tab provides access to he following Orion-Mi / nCompass CM functions:

  1. Orion-M alarm settings
  2. I/O Monitor
  3. Schedule power recovery options. 

Orion Series Alarm Settings
The Alarm Settings tab provides access to the Orion-M’s powerful alarm module that contains up to 30 user configurable alarms.  These alarms can be assigned to any loop or monitor input in the system. The Alarm settings, when completed and saved reside in the Orion-Mi / nCompass CM runtime.

EnVision Orion Series Alarm Settings

The Alarm Type selection is used to set the type of alarm.  When set to “No Alarm”, the alarm is disabled.  Available alarm type selections are as follows:

Alarm Type                             Alarm Settings
Process:                                High, Low, High & Low
Deviation*:                             High, Low, High & Low
Percent Output (% Out)*:    High, Low, High & Low
Rate of Change (ROC):      High, Low, High & Low

* Alarm type not applicable to Monitor Points: Deviation and Percent Output


Page Navigation - Jump to the specific page in the EnVision Tour
 

1. EnVision Navigation
2. Device Thumbnails Overview
3. Digital Values
4. System Alarms
5. EnVision Device Alarms
6. PC based Alarm Relay Output
7. General and Service Device Notes
8. Real-Time Trends
9. Single Loop Tuning
10. Data Logging Overview
11. System Data Logging
12. Device Data Logging / Historical Data File
13. Logging Overview Monitor
14. Historical Data File Viewing
15. Searching Historical Data Files
16. Historical Data File Trend Plot
17. CFR21 Part 11 and NADCAP AMS2750E: Historical Data files (Data Log) and Digital Signatures
18. Orion-Mi / nCompass CM Detail View

   

19. Orion-Mi / nCompass CM Detail View Tab
20. Orion-Mi / nCompass CM Detail View: Auto Tune and Auto/Manual Tabs

21. Orion-Mi / nCompass CM Data Logging Tab
22 Orion-Mi / nCompass CM Schedules Tab (Ramp/Soak Profiles)
23. Orion-Mi / nCompass CM Profile/Schedules: Run, Stop & Hold Profile Schedules

24. Orion-Mi / nCompass CM Schedule Editor Overview
25. Orion-Mi / nCompass CM Schedule Editor: Guaranteed Soak, Loops Active and Auto Start
26. Orion-Mi / nCompass CM Schedule Editor: Stage "Wait For"

27. Orion-Mi / nCompass CM Schedule Editor: Schedule Notes
28. Orion-Mi / nCompass CM - Setup Tab
29. Orion-Mi / nCompass CM Detail View - Setup/IO Monitor
30. Orion-Mi / nCompass CM Detail View - Setup/Schedule Options

 
 
 
Future Design Controls   888.751.5444   csr@futuredesigncontrols.com