PR Paperless Recorder
Page 20 of 38
 

Orion Series Detail View: Auto Tune and Auto/Manual Tabs

Orion Series Loop Control Auto Tune
Allow the user to place the selected control loop of the Orion-Mi / nCompass CM in auto tune and switch the loop between automatic and manual output control. 

Orion Series Loop Control Auto/Manual
When the loop is placed in manual output control, clicking on the percentage of output display field will allow the user to enter a manual output percentage for the loop. 

EnVision Orion Detail View Auto Tune and Auto Manual tabs

Page Navigation - Jump to the specific page in the EnVision Tour
 

1. EnVision Navigation
2. Device Thumbnails Overview
3. Digital Values
4. System Alarms
5. EnVision Device Alarms
6. PC based Alarm Relay Output
7. General and Service Device Notes
8. Real-Time Trends
9. Single Loop Tuning
10. Data Logging Overview
11. System Data Logging
12. Device Data Logging / Historical Data File
13. Logging Overview Monitor
14. Historical Data File Viewing
15. Searching Historical Data Files
16. Historical Data File Trend Plot
17. CFR21 Part 11 and NADCAP AMS2750E: Historical Data files (Data Log) and Digital Signatures
18. Orion-Mi / nCompass CM Detail View

   

19. Orion-Mi / nCompass CM Detail View Tab
20. Orion-Mi / nCompass CM Detail View: Auto Tune and Auto/Manual Tabs

21. Orion-Mi / nCompass CM Data Logging Tab
22 Orion-Mi / nCompass CM Schedules Tab (Ramp/Soak Profiles)
23. Orion-Mi / nCompass CM Profile/Schedules: Run, Stop & Hold Profile Schedules

24. Orion-Mi / nCompass CM Schedule Editor Overview
25. Orion-Mi / nCompass CM Schedule Editor: Guaranteed Soak, Loops Active and Auto Start
26. Orion-Mi / nCompass CM Schedule Editor: Stage "Wait For"

27. Orion-Mi / nCompass CM Schedule Editor: Schedule Notes
28. Orion-Mi / nCompass CM - Setup Tab
29. Orion-Mi / nCompass CM Detail View - Setup/IO Monitor
30. Orion-Mi / nCompass CM Detail View - Setup/Schedule Options

 
 
 
Future Design Controls   888.751.5444   csr@futuredesigncontrols.com