PR Paperless Recorder
Page 2 of 38
 
Device Thumbnails Overview

Device Thumbnails allow the user to monitor up to 128 devices (Loop controls, Analog input cards (6 or 8 data points per card) and Orion-M iSeries control systems (up to 15 loops & 15 monitor points per Orion) at the same time by lining up multiple thumbnails on the screen.

Alarm Indication and setpoint access are a click of the mouse away! To change the loop’s setpoint, click on the current setpoint and enter the desired value.

EnVision Thumbnail View

Thumbnails consist of 4 devices per bank. Process value (red), setpoint (green) and device status are provided. 

If the device is a loop control or Orion- Mi with profiling, each thumbnail will be updated to show the schedule run, hold and stop status as well as current stage active and time remaining.  Note that the Run, Stop and Hold buttons used for the schedule operation will not be visible and would be accessed from the Orion Detail View screen or P-Series Profiler screen.

The drop down menu allows the user to select any of the loops or monitor points on an Orion-M Device for display on the thumbnail.  Single-loop controls only provide a single selection for the process variable, since there is only one associated with the controller.

The “Logging” button on each thumbnail, provides access to the respective data logging settings for the device.  When logging is active for the device the button will be highlighted green providing a quick visual indication of the logging status for each device.

The “General Notes” and “Service Notes” button on each device thumbnail, provide access to the respective notes entry for the Device.  For additional information refer to Device Notes

Page Navigation - Jump to the specific page in the EnVision Tour
 

1. EnVision Navigation
2. Device Thumbnails Overview
3. Digital Values
4. System Alarms
5. EnVision Device Alarms
6. PC based Alarm Relay Output
7. General and Service Device Notes
8. Real-Time Trends
9. Single Loop Tuning
10. Data Logging Overview
11. System Data Logging
12. Device Data Logging / Historical Data File
13. Logging Overview Monitor
14. Historical Data File Viewing
15. Searching Historical Data Files
16. Historical Data File Trend Plot
17. CFR21 Part 11 and NADCAP AMS2750E: Historical Data files (Data Log) and Digital Signatures
18. Orion-Mi / nCompass CM Detail View

   

19. Orion-Mi / nCompass CM Detail View Tab
20. Orion-Mi / nCompass CM Detail View: Auto Tune and Auto/Manual Tabs

21. Orion-Mi / nCompass CM Data Logging Tab
22 Orion-Mi / nCompass CM Schedules Tab (Ramp/Soak Profiles)
23. Orion-Mi / nCompass CM Profile/Schedules: Run, Stop & Hold Profile Schedules

24. Orion-Mi / nCompass CM Schedule Editor Overview
25. Orion-Mi / nCompass CM Schedule Editor: Guaranteed Soak, Loops Active and Auto Start
26. Orion-Mi / nCompass CM Schedule Editor: Stage "Wait For"

27. Orion-Mi / nCompass CM Schedule Editor: Schedule Notes
28. Orion-Mi / nCompass CM - Setup Tab
29. Orion-Mi / nCompass CM Detail View - Setup/IO Monitor
30. Orion-Mi / nCompass CM Detail View - Setup/Schedule Options

 
 
 
Future Design Controls   888.751.5444   csr@futuredesigncontrols.com